222-5917 2225917 Injector Wiring Harness for Caterpillar E324D E325D E329D C7 Engine
Restore reliable electrical performance to your Caterpillar 324D 325D with the 222-5917 2225917 Injector Wiring Harness. Built as a direct replacement for the original part, it matches the factory routing, connector layout and length, so it goes in where the old one came out.
Engine reference: C7. Please confirm your engine model along with the machine model when checking fitment.
Product Details
- Part Name: Injector Wiring Harness
- Part Number: 222-5917, 2225917
- Engine: C7
- Condition: Aftermarket new
- Product Weight: 1 kg / 2.20 lbs
- Brand: TOPARTS
- Feature: Quality checked before shipping; built for heavy-duty use
Fits the Following Machines
Caterpillar 324D, 325D, 326D, 328D, 329D, 950H 962H 966D 966E 966F 966F II etc
How It Works on Your Machine
The injector harness is short, but it carries some of the most critical signals on the engine. A weak connection on a single injector circuit can make one cylinder go dead, causing vibration, smoke and a noticeable loss of power.
Sitting under the valve cover or alongside the cylinder head, the injector harness works in one of the hottest and oiliest places on the engine. It delivers the high-current firing signals the injectors need, cylinder by cylinder, thousands of times a minute.
On Cat equipment, a damaged harness often shows up as active diagnostic codes before any visible failure, so replacing the wiring can clear problems that look like sensor or ECM faults.
FAQ
Is this a genuine or aftermarket part?
Please see the Condition line in the specifications above. Every part is checked for fit and continuity before shipping.
How do I know it will fit my machine?
Match the part number on your old harness, or send us your machine model and serial number and we will confirm before you order.
How long does shipping take?
Orders are shipped by express courier such as DHL, FedEx, UPS or TNT, and you will receive a tracking number by email as soon as your parcel leaves our warehouse.
Why a New Harness Beats Patching
Splicing a damaged section can get a machine moving again, but each joint is a new point of failure. Old wire around the repair is usually just as aged as the part that broke, so the next fault is often not far away. A complete new harness resets the clock on the entire circuit.
Maintenance Advice
Replace damaged clamps and protective sleeving whenever you find them. A harness that is allowed to move against the frame will wear through eventually, no matter how good the wire is.
Warning Signs to Watch For
Watch for these symptoms:
- Black or white smoke from the exhaust
- Hard starting and reduced power under load
- Injector circuit fault codes on the monitor
- One or more cylinders misfiring
- Oil-soaked, brittle or cracked harness insulation under the valve cover
Intermittent faults like these are classic signs of ageing wiring, and they rarely improve on their own.
Fitting Advice
- Clean the area around the valve cover thoroughly before opening it, so no dirt reaches the injectors.
- Note the cylinder order of each injector lead before disconnecting.
- Inspect injector terminals and nuts; tighten to the specified torque.
- Replace the valve cover gasket and any pass-through seals while you are in there.
- Clear codes and check that the engine runs smoothly on all cylinders.
Ordering Information
- Payment Method: PayPal, Stripe, Credit card, Visa, etc.
- Shipping Method: DHL, FedEx, UPS, TNT, USPS EMS, etc.
- Track Your Order: An email containing the tracking number with a link will be sent to you as soon as it ships.
Note: Please verify your part number and match our product pictures to your original item before ordering. If you have any questions, please feel free to contact us. Thanks.





