20Y-06-22860 20Y-06-25230 Engine Wiring Harness for Komatsu PC200-6
Electrical faults can stop an excavator as surely as a mechanical failure. The 20Y-06-22860 20Y-06-25230 Engine Wiring Harness replaces damaged or aged wiring on Komatsu PC200-6 excavator and returns the affected circuits to dependable operation.
Part Information
- Part Name: Engine Wiring Harness
- Part Number: 20Y-06-22860, 20Y-06-25230, 20Y0622860, 20Y0625230
- Condition: Aftermarket new
- Product Weight: 1 kg / 2.20 lbs
- Brand: TOPARTS
- Warranty: 3 months
- Feature: Matches original routing and length; durable, heat-resistant insulation
Compatible Models
Komatsu PC200-6
What This Harness Does
Think of this harness as the communication line of the engine. Speed sensors, temperature senders, pressure switches and fuel system components all report back through it, and the controller sends its commands out along the same path.
Mounted directly on the engine, this harness bundles the circuits that connect the electronic control unit with the parts doing the real work: sensors that measure, and actuators that respond. Clean, uninterrupted signals here are what allow the engine to run smoothly and efficiently.
Komatsu excavators are known for long service lives, and many keep working well past the point where their original wiring has aged. A new harness is often the key to keeping an older Komatsu reliable.
Signs Your Harness Needs Replacing
Common warning signs are:
- Gauges for engine temperature or oil pressure reading erratically
- Fault codes for sensors, injectors or the ECM appearing on the monitor
- Engine cranks but will not start, or starts only after several attempts
- Engine stalling, misfiring or running roughly at idle
When diagnostics point to a circuit fault rather than a failed component, replacing the wiring is often the most cost-effective repair.
Fitting Advice
- Label each connector on the old harness with masking tape before you unplug anything.
- Photograph the routing, clip positions and ground points from several angles.
- Clean and inspect the ECM connector pins; bent pins cause more faults than people expect.
- Clear stored fault codes after installation and run the engine to working temperature to confirm everything reads correctly.
Keep Your Machine Earning
Electrical problems tend to get worse rather than better. Replacing a deteriorating harness at a planned service interval is far cheaper than dealing with a breakdown in the middle of a job, especially on remote sites.
Construction and Quality
We check connector fit, wire continuity and overall layout before shipping, so the harness you receive is ready to install. The materials are chosen for the temperature range, vibration and contamination found on construction equipment.
Make Sure It Fits
Before ordering, compare the part number printed on the label of your original harness with 20Y-06-22860 20Y-06-25230. It is also worth comparing the connector shapes and the number of branches with our product photos. If your machine's serial range or engine variant differs, send us your machine details and we will confirm compatibility before you buy.
Shipping and Payment
- Payment Method: PayPal, Stripe, Credit card, Visa, etc.
- Shipping Method: DHL, FedEx, UPS, TNT, USPS EMS, etc.
- Track Your Order: An email containing the tracking number with a link will be sent to you as soon as it ships.
Note: Please verify your part number and match our product pictures to your original item before ordering. If you have any questions, please feel free to contact us. Thanks.





